让RED EPIC永不断电,QUAD电池模块,

2011-10-18 15:18
\"\"

在REDuser中Tim Whitcomb为RED EPIC摄像机提供了一个电池解决方案。具体的流程大家看英文吧。

\"\"

The days of powering down to change batteries is ALL BUT OVER FOLKS!

Been pulling out random VOLTs… as long as 1 stays in… Keeps on going and going… I have been leaving it on now for 1:45 minutes recording boring camera charts in my prep room and haven’t powered down once! (MAN I NEED A QUAD CHARGER THOUGH TO KEEP UP!)

Appears to power SEQUENTIALLY… which is great.. only ONE RED VOLT powers at a time… so its easy to keep track as you go (because its a prototype… in camera batt level monitoring is not enabled yet.)
Right now they drain rear to front. I.e Left Rear then Right Rear. The Left front and finally Right Front. At least on the module I have. I don’t see any value to draining them at the same time. How would you hot swap? If you want less Swapping… remember the Red Volt XL is coming and takes up TWO spots. So you would just flip left and right Volt XL’s. (What I plan to do)

\"\"

Summary: One HOPES that the side handle would drain last… so when you lose all 4 Red Volts in the Quad, you can keep going while you swapping.
What this does is let you HOT SWAP and never have to power down! unlike changing a RED BRICK on the R1.
I am telling you attaching your first module to your EPIC is a religious experience … I almost feel guilty being among the first outside of RED… almost.
You will not appreciate how GENIUS modules are until you start attaching them for the first time… All that WIRE GACK… is reduced to elegant pins and connectors. Freaking awesome!

\"\"

来源:http://cinescopophilia.com/prototype-red-epic-quad-battery-module-never-power-down/

本文为作者 分享,影视工业网鼓励从业者分享原创内容,影视工业网不会对原创文章作任何编辑!如作者有特别标注,请按作者说明转载,如无说明,则转载此文章须经得作者同意,并请附上出处(影视工业网)及本页链接。原文链接 https://cinehello.com/stream/2659